Magnum inverter MS2012--Internal bridge error message

[TexasTwoStep]

I am getting an "internal bridge" error message on my inverter monitor and have reset the inverter by unhooking all power including the batteries and still get the message. Has anyone else experienced this?

[757driver]

Originally Posted by TexasTwoStep

I am getting an "internal bridge" error message on my inverter monitor and have reset the inverter by unhooking all power including the batteries and still get the message. Has anyone else experienced this?

No, I have not experienced it before but after completely removing power from inverter (including shore power) for 30 seconds and you still have the fault it is time to take the inverter to a repair facility.

[Freightguy]

Originally Posted by TexasTwoStep

I am getting an "internal bridge" error message on my inverter monitor and have reset the inverter by unhooking all power including the batteries and still get the message. Has anyone else experienced this?

So what happened?

[FLYING BUTCH]

That isn’t a good reading. Might need module replaced BUT mine had same reading but ended up just a loose wire? Good luck

Safe travels akk