Community Forums

thunderjet · 07-24-2024, 02:37 PM

I have one Coleman Micro-air easy touch thermostat,
that controls 3 roof top ac/heat pumps and floor heat zone plus two space heater zones.
I would like to replace it with a Coleman ASY-355 so that I can run these units from my Iphone.

Does anyone have any experience, with this product?

My thermostat is installed in the bathroom cabinet with temp sensors in different parts of the RV.
RV is a Entegra 44w.

thanks TJ

TB673 · 07-25-2024, 12:15 AM

The MicroAir EasyTouch Thermostat should be WiFi and Bluetooth equipped. I know that mine is.
What is it not doing?

Tim

thunderjet · 07-25-2024, 07:46 AM

you are right.

! gave wrong info on old stat
Old unit is a multi zone ZC hard wired,

easy touch is what I would like to install.

install looks easy just plug in.

My wife is not into tech which means every time she is too warm or cool I will be popping into the half bath, opening the cabinet to adjust stat.n

I will check on line to see the Iphone inter face app

TJ

TB673 · 07-26-2024, 08:59 AM

TJ, my wife is all over the place, temperature wise.
I have an Android phone, and I can change the temperature from either across the room, or from the bed.

Tim

cdm747 · 07-26-2024, 09:06 AM

I installed the Micro Aire T Stat. Plug and play however you still have to do some initial programming such as selecting what type units you have at each location. You have to select if you have a standard AC, Heat Pump or heat strip and/or furnace for each location, pretty easy once you start. All setup is done on the iPhone app so you have to select bluetooth and select your wifi a well. All in all fairly easy.

thunderjet · 07-27-2024, 07:07 AM

Thanks for the replies.

Wife and I decided to try a few months with present stat as is,
with a change out if needed. trying to keep cost down.
My wallet is looking at new tires, dishwasher, and starting batteries.

TJ