Norcold 1095n cooling question

[bwanna2016]

this is a 2 year old amish cooling unit.yesterday, i walked by my lower vent panel and noticed the fan was not running. i pulled the cover and the absorber vessel and coils were cool to the touch. i switched to propane and turned the thermostat up to 9. the burner did not kick in. after scrambling around for about 30 minutes going thru the diagnostics, the fridge cycled on again. is this normal for the fridge to cycle like this? i had never noticed it kicking off before, so if this is not normal, i'd like to get ahead of any problems. thanks

[Old-Biscuit]

Heat sources only come on when cooling is needed.....based on thermistor feedback to thermostat

Fan only runs when Condenser FIN temp reaches 130*F which only happens when heat source is ON and ammonia is boiled into hot vapor

Were fridge temps 'warm'?

No error codes?

Any stored Fault Codes in Diagnostic Mode?

[bwanna2016]

the fridge was 40 degrees. there were no error codes. i had never noticed the coils or the absorber vessel being cool before. is this normal?