Our slide-out skipped a beat going out.
Starting and stopping and starting before going out all the way, and the motor didn't shutdown automatically when it was out all the way.
Had the wife close the slide while I watched from underneath/outside.
Looked like the gear didn't turn continuously (but not jumping gears) when the axle was turning. Enough turning to get the slide in but not synchronous movement between the gear and the axle.
I suspect the pin going thru the gear and axle is sheared but still providing some friction.
Any advice on how easy it is to remove and replace the pin? Seams like I might need to pull the entire assembly to do the job.

