SeeLeveL wiring question
I am installing a SeeLeveL tank monitor in my 2021 Arctic Fox 27-5L.
Most of the installation process seems pretty straightforward, but I have a question about wiring. It may be a dumb question, but here goes:
The sensors on the system run a ground wire to the display and to the “system ground.” It seems that all of the 12-volt wiring is grounded to the RV chassis. Is it reasonable to simply connect the ground wire to a Tek screw in the chassis?
I am planning on getting power for the display by tapping into the hot side of a switch on the existing control panel.
I am attaching a bit of wiring diagram from the manufacturers literature to help explain this.
2018 F350 Limited, 2021 Arctic Fox 27-5L
300 Ah Battleborn LiFePo4, 3kw Victron Multiplus, 600W Solar, SeeLevel