Surge Guard 40250-RVC Cover Removal

[MathComp]

I want to remove the cover of my Surge Guard 40250-RVC ATS, but I'm not sure how. There are two Phillips head screws in diagonal corners of the unit's face that has all the printing, but the other four small circular things look like rivets. Simply removing the two diagonal screws didn't seem to allow me to remove that face. Do I need to remove the unit from the wall of the compartment it's mounted in so that I can access additional screws on other faces?

Thanks,
Paul

[davo54]

Yea, that stumped me too. It's just spring clips holding it on after you remove the two screws. The cover will pull off with a bit of a tug.

[Lt Dan]

Just give it a tug. The rivets that are visible on the face are just holding the spring clips in place.

[MathComp]

Oh, thank you, thank you, THANK YOU both!