Good Morning,
I have a 2002 Thetford Aria Deluxe II that was not holding water in the bowl. I removed the toilet, flipped it over and removed the motorized blade. Changed the gasket, cleaned the blade assembly and reinstalled and reinstalled the toilet. After testing and all worked great, I sat down with the wife and talked for 10 min.
Suddenly, the toilet sprang to life and started going through the flush cycle - over and over....I stood above it in disbelief until I pulled the fuse and started wondering if I put the 2 wires in the right spot!
After 3 or so tries of putting the fuse back together, the fuse started to blow. It was the old glass fuse, so I cut it out and put in a new blade style fuse (4a).
Still blowing fuses and I'm super frustrated. Any ideas?
There are 2 solenoids that open valves for water, there is a motor that runs the blade in and out, and other than that, no other motors. There is a control panel in the bottom and a dual flush push button (electronic) at the top. Is there a way to test the solenoids and blade motor to see if they are working? I did not want to hook them up to 12v without a fuse.
Thanks in advance!
Here is the owners manual:
https://www.thetford.com/wp-content/...ual_19824A.pdf