Quote:
Originally Posted by Caliwes
Ya I cleaned it already but maybe I need to be more detailed. And I didn’t clean the orifice so I’ll do that cause if it’s semi clogged I’m sure it would cause this too. I’ll also check the voltage. Thanks for the help and the manual. I’ll just be more detailed in my cleaning this time around to ensure it’s not just dirt or something.
|
Dirty orifice......fuel/air does not mix properly
**soak/air dry-----if you blow it out or poke anything thru it you will damage the laser cut metered hole
Burner tube not 'aligned' with gas valve...fuel/air does not mix properly
Burner tube 'spreader plate' not parallel with end of tube....sputtering