I noticed on the way back from picking up our 2004 Itasca Suncruiser 33V that the cruise control didn't work. Check the fuse. Any ideas on a simple fix?
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
I noticed on the way back from picking up our 2004 Itasca Suncruiser 33V that the cruise control didn't work. Check the fuse. Any ideas on a simple fix?
<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by Lindsay Richards:
I noticed on the way back from picking up our 2004 Itasca Suncruiser 33V that the cruise control didn't work. Check the fuse. Any ideas on a simple fix? </div></BLOCKQUOTE>
Lindsay,
If it is a Ford it should be disconnected until the recall service is performed on it. Millions of Fords are being recalled due to a fire hazard involving the cruise control and many are being disconnected as the parts to repair them are in short supply.
On member had his put back in service by uninformed mechanic and then experienced a fire.
If it is a Workhorse it could be something as simple as the switch on the brake pedal that shuts it down when you tap the brakes needs adjustment.
__________________
Neil V
2001 Winnebago Adventurer WFG35U
I had a 04 on the Workhorse and had the same problem. The tech adjusted the plastic switch that hits the brake pedel when its depressed on the steering post and it worked fine. Do not remember much more, maybe someone else can explain how the disconnect for the CC works on this switch. s/Toby
__________________
2006 Holiday Rambler Ambassador 38PDQ
Click on SHIP to enlarge CGC Sagebrush
If the steering wheel was adjusted into full upright position the cable or harness is sometimes strained which causes a disconnect. with wheel fully down grab harness and push upwards toward wheel. Take note of cable position. Now, adjust wheel into full upright position. If cable doesn't follow the wheel upwards you need to find some slack under the dash to relieve the strain. Good luck!!
https://www.linandnancy.com
Linear Mode
