They are pretty tight press fit. If you have removed the allen set screw completely, you'll have to pry them off. If you are replacing the blades, then break it off.
I made a puller out of supplies in my shop to pull it off. I did have the advantage of having the assembly on the bench when I did it.
Try heating the fan stem where the screw is with a hair dryer to expand it a little. The plastic will expand faster than the steel shaft as long as you use min heat.
__________________
2020 Coachmen Leprechaun 270QB (COA Member)
Jeep Wrangler toad for the dirt
"Well done is better than well said"....Ben Franklin
|