RV Luminaire VR bulb change

[nhinze]

I'm trying to get to the bulb of one of my RV Luminaire VR ceiling lights. I got it out of the ceiling and was able to pop it out of the frame. However, I still can't get to the bulb. See attached picture. What's the next step? I can see any screws.

The trailer is a 2006 Jamco Horse Trailer with LQs.

[RickLight]

In the fist picture, at the bottom of the lower piece I see what might be a pry spot. Perhaps just enough for a 1/4" flat screwdriver.

I know light fixtures, but nothing about horse trailers...

[nhinze]

I ended up replacing them all with an LED equivalent. Uses a lot less power and they do not run so hot anymore. https://www.superbrightleds.com/2-5-...Brushed~Nickel

[zigzag930]

In case anyone else ever has this same issue, despite what the factory says - you can replace the bulbs. In fact, it's simple.

Simply pry on the inner bezel (closest to the lens) and the bezel and lens will pop right out. Then, change the bulb with a 10w 12v bulb, push the lens and inner bezel back in and you're all done.

[MRG1962]

Our thanks to zig-zag930 who advised us that you can pry the bezel and lens out of the RV Luminaire VR Puck Lights and replace the bulb itself instead of buying and re-hard wiring.the entire puck light assembly. Big Savings! Only had Halogen bulbs on hand and they are hotter so will get LED next time. Although, in the winter climate we RV in at our land in Colorado, every bit of heat source is appreciated. ��������

[4x4van]

Be careful! The additional heat from the Halogen bulb in a fixture not designed for it...risk of fire?