The check valve in my old water inlet is leaking. I bought a new water flange, but it doesn’t have the white sealing on the bottom that the old one has. I cannot remove this plastic part from the old one. Where can I buy such a sealing ring?
I have tried to put Teflon tape around the thread, but it is still leaking a little bit.
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
OK, I think I got new ones of those when I replaced my water pump , I'll need to go to the coach to look at them from that angle . BRB.
EDIT: Back in time to add pictures here.
I believe your fitting ( shown in your last picture ) is broken , and the broken portion has jammed the tapered seal ring in the brass fitting.
Picture 1 , is the install kit that came with my new water pump.
Picture 2, the fitting showing the ridge that holds the two pieces together on the outside .
Picture 3, the ridge inside the nut , I'm thinking your fitting is broken at that ridge , and needs to be replaced .
__________________
99DSDP 3884, Freightliner, XC, CAT 3126B, 300 HP /ALLISON 3060
2000 Caravan toad, Remco & Blue Ox.
A second thought ; I always have them ; In the years between our coaches being built , perhaps the fittings have changed , but , if the fitting isn't broken then the issue with leakage would be that the deformed hardened surface of the seal ( due to years of compression ) will no longer conform to the inner surface of the fitting.
EDIT: My speed reading needs work ( still ) : just realized your trying to seal the new water inlet without the tapered seal .
The soft rubber tapered seals I've pictured are for use with the shouldered fittings , not the flat surface type you have .
Did you purchase the water inlet locally ?
I'll see if I can find a P/N or supplier for the tapered seal ; JMHO , the new part should have come with one.
__________________
99DSDP 3884, Freightliner, XC, CAT 3126B, 300 HP /ALLISON 3060
2000 Caravan toad, Remco & Blue Ox.
The picture shows the old water inlet. It was not leaking at this white plastic sealing. The fitting is also not broken. Maybe I can pull out this white plastic with pliers, but then the plastic will be broken.
I would just like to find a source where I can buy a new sealing ring. If I would know where I could search for...
Every RV owner should have a water alarm near and under groups of piping. My RV had a small leak for months/years that ultimately destroyed the bathroom floor.
I mounted a few of these behind the walls of my storage compartment where a lot of plumbing is exposed. I put one directly under the toilet, another next to the 12v water pump, and the third directly below the shower drain.