circuit board for shurflo water pump?

[RAM1961]

Apparently the circuit board for water pump gave up the ghost and was not replaced. I have no idea what I am even looking for. Jury-rigged a toggle switch to get water flowing. Any ideas where to start? Thanks in advance.

[rv.guru]

What type of coach do you have??? There is a latching relay on some coaches for the water pump, usually brown says intellitec and water pump on it, aprox 2"x2" square and about 1/2" thick, has aprox. 4 wires on spade terminals, should be somewhat close to pump.

[Gary RVRoamer]

If you mean the pump relay as rv.guru described, it should be available through most any RV dealer. It is a latching type relay.

[RAM1961]

The motorhome is a 1990.5 Bounder Class A. This circuit board or relay or whatever was tucked into one of the outside compartments where the water pump resides. Previous owner did not keep the faulty board so I have no idea what it was - but he did mark the wiring on the wall where it was mounted. Appears to be a four wire setup - two of which I assume are straight from the pump. The motorhome has three separate water pump switches - one right there at sink, one in the bathroom, and one in the little sink in the corner in the bedroom.

Hope that helps to point me in the right direction.

[rv.guru]

Yes that is excactly what you are looking for, all of the switches should be momentary to work with the relay, look at this pdf I think on page 5 is what you are looking for, gives you the part # as well
http://www.intellitec.com/pdfs/catalog.pdf