iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Even if there were or you welded some up I would not trust them UNLESS your base-plate is attached to the FRAME of the Jeep securely and you can TRUST it.
That is where all recovery rings are attached. Look at the Hummer.
The base plate is attached to the frame, so that's not an issue, it is that the BlueOx double tabs are 1 1/2" Outside, and the only ones I can find that list that measurement are for 1 1/4" Clovis tabs.
__________________
2018 Fleetwood Pace Arrow 36U
2014 Wrangler JKU Rubi
Buy A set of Blue-Ox pins, cut off the twin tabs on the front and either weld a set of pulling rings on the front of each tab or drill a hole through the pin then use a set of clevis pins will fit the hole.
However by drilling that weaken the sold piece of steel so I would choose to weld a fixture on the front that will be for pulling.