Found this set of “sink sockets” in the plumbing section at Home Depot.
I used these to remove a wheel simulator nut that I did not have a tool for. Takes a big socket and the largest one did the trick!.
I also used one of the smaller ones to run my 9/16-18 die over my wheel stud that had been cross threaded on the end making it unuseable, which also required a socket type tool much bigger than anything I had. Only $23 for the set. I can picture many more uses down the road. They really helped me out, so I just thought I would share.
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Good find.
I'll bet this multitool works on sinks too.
Saves carrying a whole tool kit.
Mike in Colorado
__________________
2004 Fleetwood Pace Arrow 37c, 8.1 gasser, (Jezebel) Ultra RV ECM / TCM, plugs wires, and rear track bar, PPE deep Tx pan w/ temp gage, Bilstein's, Sailun's & Sumo's all round, pushed by a 2002 Grand Caravan, on a Master Tow Dolly OR a WR-250 on a rail.
Linear Mode
