Iím in the process of installing a readybrake controller and tow bar to tow a 2015 expedition behind a Jayco Seneca. Wondering what the preferred methods for lighting and/or charging system for the car people are using?
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
I used a wiring harness from Hopkins and was actually cheaper from the shop that installed the base plate. Required having to run wires to the back lights but well worth it because it had factory plugs to tie into existing harness. eTrailer.com also carries a harness that you splice into existing wires and uses diodes. They have a few options from yours https://www.etrailer.com/tbwiring-20...Expedition.htm. I had to add a brake relay so turn signals would work while brake is applied. Not sure if the diodes from etrailer does that for yours. You may want to check you tube to see if someone shows how they set up their toad. Good luck and happy trails.
Matt and Jackie
'12 Tiffin Allegro Bus 36 QSP
'16 Jeep Wrangler Unlimited-Ready Brute Elite towbar