LT Dan & FL Steve Mopar Harness
I would like to thank both of you. Steve, your instructions really helped. LT Dan, the advise on removing the glove box and speaker really worked. Don't think I could have done it with our the access that this provided.
Harness is installed. Tomorrow I will try to figure out how to test it without the motorhome. I assume I can just pull power from the jeep battery for the 12 volts on pin 4 and then jumper that to the individual light inputs.
BTW, I only had a 1 1/2 inch hole saw. Worked like a champ. I think that the biggest problem was figuring out how to release the connectors. That and getting to them.
Again, thanks. If I had to follow the Mopar instructions it would have been a disaster.
Jim
|