I have a 2025 Sierra SLT 4x4 to tow behind a Phaethon 40qth (2013)
Im just setting it up to tow. I purchased the RM tow wiring kit with the diodes to splice into the truck wiring. Would this a correct option ?
E Trailer only showed a couple.
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
It's either that or a separate set of magnetic lights that you put on the back of your toad. On my first toad that I could flat-tow I used the diodes. On this toad (which requires a dolly) I use the separate lights.
__________________ Larry & Cheryl Herman - Ranger, Henry, Georgie & Enzo (our Springers)
2019 Tiffin Allegro Bus 45OPP
2016 Ford Transit Connect on a Demco dolly
I'm using a home-built version of the CoolTech LLC wiring harness: a 4 pole double throw switch installed on the dash of our Jeeps that sends power to the tail lights from either the Jeep's wiring harness or the RV's wiring harness. It requires finding the correct wires in the Jeep's harness and cutting them but works great. If you have OEM LED tail lights you'll need another line to switch off the signal going to the Jeep's BCM but if you have non-LED lights then you only need to switch 4 lines.
__________________
Alan Hepburn - Lewisburg, TN
2007 Bounder 35E being pushed by a 2020 Jeep Gladiator Sport S or a 2022 Jeep Wrangler Unlimited (JLU) Sport S
Something I learned from forum member "First Light". Curt makes a plug and play wire harnesses specifically for some toads. It appears Curt# 58984 might be for your truck.
Something I learned from forum member "First Light". Curt makes a plug and play wire harnesses specifically for some toads. It appears Curt# 58984 might be for your truck.
STOP.....don't use the kit. I just set up my 2024 GMC Sierra Denali in November. Curt makes a plug and play wiring setup. You just disconnect the two connectors at the rear of the truck, plug theirs in and the OEM back into those. It has one ground wire you screw to the frame then route the grn/whi/yel/brn wires to the front of the truck. Use split wrap and secure with zip ties.
Linear Mode
