2017 Holiday Rambler Vesta Class C- Leveling Jacks - Slides

[frogmangmg]

So, i need to start at the beginning as it might be relevant to someone helping me out. I brought the rig out of storage knowing I might have to replace the batteries. I attempted to open the large slide, the room slide out panel flashed low voltage and it would not move the slide at all. So i let it charge over night and in the morning attempted to open the large slide out, it moved it out 85% of the way but then once again showed the low voltage light. I replaced the batteries, but still go the low voltage light. I then proceeded to lower the auto leveling jacks which worked fine up to the point where LCI Electronic Levelers display showed the Left arrow flashing, and the display bubble light showed Jacks down which in fact all jacks are down on the pavement. Now, the Room Slide Out Display panel now won't do anything, no lights no nothing.

I am thinking I need to somehow reset the jacks, but bewildered why the slide not does not respond at all. Assuming because the it thinks the leveling jacks have not finished their job.

I read some threads that say that the breaker needs to be reset, yet I see know where for a breaker.

Thoughts

HELP!!

[Beach Walker]

It sounds like you are not plugged into shore power? On my motorhome I’m supposed to be plugged into shore power or have the generator on to lower my levelers. Is it possible that the batteries were not fully charged? You might have drained the last bit of energy from the batteries by lowering your levelers and that may be why the slides won’t respond.

[sgt1577]

I have the Fleetwood Jamboree that is identical to your HR. You didn’t mention it, but was the engine running during all this?

[frogmangmg]

got it fixed y'all. It was the 200 amp fuse on the chassis coming off the battery

thx for your help. FYI for anyone that this might help, The slides and leveling system all run off the chassis battery which supplies voltage through the fuses in the house batter compartment, thus why the key ignition must be turned on in order for the slides and levelers to work-- it should have dawned on me to check any inline fuses from the chassis battery... :(