Slide seals and noise

[Monaco Dave]

Good morning All,
I have moved into a Coachman Prism and have a few issues I would like to resolve, wondering what others have done.

First off, it is tremedously noisy on the road, anyone try to soundproof the floor boards or anything?

Second, the seals on the slide aren't even close, bottom gap of about half an inch the length of the slide. I am wondering if I can remove the bed to gain access or where a guy might start on a repair like this?

In advance, thank you for your generosity in sharing experience and knowledge.

Best regards,

Dave

[kwftlaud]

i did a lot of work on my slides ( hwh hydraulic slides ) .
There are adjustments on the bottom that can change the angle of how the slide pushes against the side.
Since you say its consistent across the whole bottom, you may be able to just adjust it away.

If the slide is old, you might have some plastic slide pads than have worn away and thus changing the position of the slide.

Kip