Thank you very much busyguy.
Scot Halberstadt P.O. Box 244 Leming, TX 78050
(469) 235-8035
I think the fuse that I need to replace for the inverter is on the passenger side of the Boost Start relay, but I cannot tell if it is the middle or outer of the three(?)
I am unable to pull the dog house off for better viewing/access which does not help the situation.
Busyguy,
I read that you own a 2000 Harney.....small world.
From one of your posts, I read that you have the electrical drawings for this rig?
I am in the restoration/upgrade phase with my "Renegade" and a about to replace a Freedom 458 inverter 1000W with a 2000W, dual breaker version.
I have the new 2/0 cabling and 300A fuse.
What I do not have, and your elec schematics may assist with, is the high Amperage DC fuse locations on the rear "firewall".
There are several and it is hard to get access to that area from below (you would not know the trick to pulling the cover off the engine doghouse with a 90 degree opposed bed?)
I cannot see which is the inverter NL fuse as I cannot get close enough to read the labels.
Any help you could afford would be greatly appreciated and thanks in advance.
.....about to install the new PTL Engineering outer seal for the front door....read your post that this is a PITA task!!
