iRV2 Forums

iRV2 Forums (https://www.irv2.com/forums/)
-   Fleetwood Owner's Forum (https://www.irv2.com/forums/f107/)
-   -   1995 American Eagle (https://www.irv2.com/forums/f107/1995-american-eagle-1027.html)

jDavid 02-08-2009 06:25 AM

Does anyone know if a 1995 Eagle is prewired for electric brake controllers? I recently purchased a 95 and pin 4 (blue of 7pin rv connector) has 12 vdc when ignition is on? I would like to install a brake controller for my horse trailer brakes.

exrench 02-08-2009 06:03 PM

You can't hurt anything if you go to the back of the rig with a test-light and ground one end of the test-light and apply the prod in turn to each of the conductors in the plug.If the light comes ON then you have 12VDC.

Gary RVRoamer 02-09-2009 06:38 AM

There is an American Coach Yahoo Group where you can learn a lot about your coach. Many vintage AC owners there, as well as newer models. You will find discussions of adding brake controllers there if you search the message database.

AC Owners Yahoo Group

As I understand it, AC did not begin actually wiring for the controller until 2004, but earlier models had some wiring present to make the job easier, e.g. a wire run from dash to the vicinity of the 7 pin plug. However, a previous owner may have already added what is needed.

Pin #4 is a constant 12v signal and is normally black in the 7 pin Pollak/Bargman connector. Pin #2 [blue] is for trailer brakes and should only have 12v when the controller is installed and actively braking.

7 pin RV Connector Wiring


All times are GMT -6. The time now is 03:05 AM.

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2021, vBulletin Solutions, Inc.