iRV2 Forums

iRV2 Forums (https://www.irv2.com/forums/)
-   Monaco Owner's Forum (https://www.irv2.com/forums/f115/)
-   -   Water sensor wiring (https://www.irv2.com/forums/f115/water-sensor-wiring-123932.html)

R2Home 05-15-2012 10:45 PM

Water sensor wiring
 
Does anyone have a method to replace/splice a new wire for the water level sensor? One of the wire on our 2003 HR Endeavor was ran behind a support for the fresh water tank and finally wore through. The wire is about the size of a dozen strans of hair. I do not image that soldering is the best method. I need not only to repair the wire but to add about 10" in lenght to re-route it. Besides there is NOT much room to work in the water bay.

Skip426 05-16-2012 12:46 AM

Try to match the wire size, if you can, mostly to avoid overheating the smaller wire when soldering , Install "shrink tube" before you twist the wire, for both joints, use a thin electronics solder, and a dual heat solder gun on low for that small a wire. Shrink the tube with a match or hair dryer. Good luck.

Barlow46 05-16-2012 06:55 AM

You might try something similar to this. https://www.calcentron.com/Pages/elek...connectors.php

JimM68 05-16-2012 12:39 PM

Gawd i hate it when my phone weirds out and deletes a post...

I put a seelevel2 system in my knight this spring, and it is great.

wa8yxm 05-16-2012 06:48 PM

Soldering works fine, So do crimp on connectors


All times are GMT -6. The time now is 06:49 PM.

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2021, vBulletin Solutions, Inc.