River Park Speaker Switch
 

I just upgraded from the stock Magnaydyne 9900DVDS to a Magnadyne M3-LCD. Easy switch over using the same harness and dash can. The problem I have is the front speakers do not work. :banghead: I'm assuming there is some type of conflict with the River Speaker Park switch (#6CHXOV-01). I switched back to the 9900 and the front speakers work fine, so I know the switch is good.
Any ideas are appreciated.:bow:
Thanks in advance.
Mike G.
2008 Camelot 36 PDQ

I would make sure there is speaker wiring comparability between the two Magnadynes.

Got it resolved.
The River Park speaker switch needs 12V from the dash radio to turn on the front speakers. That power typically comes from the blue "Remote" wire on the radio harness of the 9900DVDS to pin #5 on the speaker switch. The M3-LCD blue remote wire is a stand alone and not in the harness plug. I soldered the blue remote wire from the radio to the harness and all works well and sounds great.:dance:
Thanks for your response itdave.
Best,
Mike