Power Cord reel Remote control programming
 

I have a motorized Glendinning power cord reel. This is an older model.
It has a remote control for it: Hatch-It
They are out of business
This is like a garage door opener type mostly used for marine applications

I have a remote key for it and i had to change the battery
Now the motor (power cord) wouldn't go IN or OUT

Obviously i will need to program it so the remote and base station is synced.

Any suggestions on how to do it?

I have googled it and i am unable to find a programming manual

Best Regards
jim

Is this it? If so, call these guys and see if they can send you a pdf for the remote?
Cablemaster Wireless Remote Control

Yes it is something similar.
Mine has two buttons - open and close

I am going to look into the one you suggested and see if i can program mine the same way.

When i put a new 12V battery in the remote, the LED keeps blinking forever.
So i am guessing, it is looking to sync up to the base station...but i am not sure

Worst case, i will use the switch on the console.....