iRV2 Forums

iRV2 Forums (https://www.irv2.com/forums/)
-   Monaco Owner's Forum (https://www.irv2.com/forums/f115/)
-   -   Bedroom slide (https://www.irv2.com/forums/f115/bedroom-slide-194705.html)

luckyd 02-28-2014 07:57 PM

Bedroom slide
 
2002 Monaco Windsor Double slide

When the bedroom slide is "OUT" the rear is
not quite fully sealed. This causes water to seep in
during heavy rains.
When the slide comes "IN", the mattress hits the cabinets
and straightens out, fully sealing the slide.

How do I adjust this? There is only one rail with cogs
so where is the adjustment??

Help would be appreciated.

sizzler 03-02-2014 03:00 PM

Do you know what make and/or model your slide is?

luckyd 03-02-2014 07:47 PM

Apparently it is a Lippert with a Dewalt motor.

Have not found any adjustments on this.
Took all the panels off under the bed and found nothing.

Lippert does not show adjustments, only parts.

sizzler 03-02-2014 08:43 PM

Try to identify your unit here:
Slide-Outs - Customer Support

In each selection you can find FAQs and documents where you can find trouble shooting and adjustments. There will be a control panel somewhere in the coach. Many of the coaches I have had, had the controller on the ceiling of the basement compartment most below the slide. Many of these controllers will have error code LEDs on them, but with your issue, there is not likely any error codes. You will need to look at the adjustments for the issue you are experiencing.

If you can find more details of which model you have, I maybe able to be of more help. I hope this is of some help at least?

Take Care,


All times are GMT -6. The time now is 06:33 PM.

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2021, vBulletin Solutions, Inc.