Quote:
|
Quote:
|
Thanks for the pointer to the files page.
Mine is the Ford F-53 chassis with V10. I'm normally a BBC guy, but I'm liking this set-up just fine. |
Quote:
|
1 Attachment(s)
My "new to me" 1999 Pace Arrow Vision has a single seat recliner behind the Pax seat. It swivels, it reclines, but the lever that I think actuates the leg lift won't budge. What am I missing?? Is there a release?
|
Have someone wiggle the lever while you look underneath the chair. You will be able to figure out what is wrong. The lever should work easy so something is binding or not releasing.
|
Got under the seat. Clearly someone has disabled the leg-lift component. There are 4 not-original bolts installed in the mechanism to prevent the leg-lift motion. Is this something that Fleetwood did ?
Do other people's Fleetwood Motorhome recliners function with normal leg-lift? |
Quote:
|
Quote:
|
loose dash
purchased my 04 pace arrow may 18. dealer bolted dash down on pass. side because it moved up and down 3/4 in. repair lasted 20 miles?, so i went looking myself, discovered sidewall loose , behind wire loom on pass side under hood is angle iron vertical to front support.attatched with alum. screws. all heads sheared off. used floor jack, 18 in piece of 2x4 to jack sidewall back where it belonged, drilled new holes and used 1/4 in s.s. lags 1in .long . 15 thousand mi. no rattle
|
GerryB, it's a common PA problem of that time frame. My '06 was the same. Unfortunately cost me mucho $$ to find a place to do exactly what you did.
|
Very poor design point to say the least.
|
AC Replacement
Wondering if anyone has replaced Roof AC unit on a 2004 Pace Arrow. Our 13,500 BTU Mach 3 Power Saver has stopped working properly and it appears to be a bad compressor. Due to Covid, the units are on a backorder for 6+ weeks. Was wondering if any of the other Coleman's such as the Mach 3 Plus or the newer Brisk II would also work?? Really want to just plug it in where the other comes out
|
AC goes in and out easily. Remove inside panel and have a look. If in doubt get measurements and give to supplier, confirming units are interchangeable. You and I are not the first, nor the last, to have this problem. :cool:
|
All times are GMT -6. The time now is 08:32 AM. |
Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2022, vBulletin Solutions, Inc.