iRV2 Forums

iRV2 Forums (https://www.irv2.com/forums/)
-   Fleetwood Owner's Forum (https://www.irv2.com/forums/f107/)
-   -   Bounder: Slideout Problems (https://www.irv2.com/forums/f107/slideout-problems-541090.html)

ddconne 06-13-2021 06:48 PM

Slideout Problems
 
2014 Bounder 35K. Both slideouts quit working at the same time. won't go in or out. Help

KF5UMC 06-14-2021 03:04 AM

1 Attachment(s)
I would suspect a loss of 12 volt DC power to the electric motors of your slide outs. On our Discovery coach you must have the engine running to operate the 3 slide out rooms. In one of our compartments are 3 large relays with fuses for the slide outs. I have attached Power Gear ELECTRIC operated slide outs as a guide to help you. Crawl under the coach and determine the type of slide outs you have, where the motors are and follow the wires from the motors to the fuses....Good Luck
John
Attachment 332046

US1 06-14-2021 06:11 AM

Ebrake set?

mttop 06-14-2021 07:13 PM

What US1 said…

ddconne 06-15-2021 04:38 PM

slideouts now working
 
Thanks for the info... I found another fuse panel. BOTH 25 amp fuses had to be reset. I am now good to go. Seems strange that both would pop at about the same time. anyway, thank you all again for the help.

Bldgest 06-17-2021 04:27 AM

Quote:

Originally Posted by KF5UMC (Post 5790655)
I would suspect a loss of 12 volt DC power to the electric motors of your slide outs. On our Discovery coach you must have the engine running to operate the 3 slide out rooms. In one of our compartments are 3 large relays with fuses for the slide outs. I have attached Power Gear ELECTRIC operated slide outs as a guide to help you. Crawl under the coach and determine the type of slide outs you have, where the motors are and follow the wires from the motors to the fuses....Good Luck
John
Attachment 332046

Thanks for posting that. My new to me 2015 Bounder 35k did not come with this info. Just yesterday I was under lubing and seeing how I would get the slides in or out in case of a failure.

PaulVK 06-22-2021 02:41 PM

I have a 2015 Bounder 35K, also new to me, and I always worry when I push the slide switch. I will look for the fuse boxes.

Technoid 06-22-2021 03:44 PM

Check the switch on the parking brake. It must be activated and the stabilizer legs down.

Trek8288 06-22-2021 04:25 PM

IF your batteries are low amps the slideouts will not function. Check your batteries. Also there are Relays that function of the house. I had to replace a Relay once to correct my slideout problem. You might run the engine and try to operate slide outs, this will, may, tell you if your batteries are weak

EdandMinnie 06-30-2021 02:44 PM

Can you post a photo of the fuse panel? I have a 2014 35K as well and would like to know where the fuses are located in case I run into to same issue.

Thanks

ddconne 07-01-2021 06:25 AM

I don't know how to post a picture, but the fuse panel is in the propane tank bay. just above and to the left. large panel.

CLIFFTALL 07-01-2021 06:27 AM

See post #8 here.

https://www.irv2.com/forums/f62/foru...ics-49134.html

Quote:

Originally Posted by ddconne (Post 5813824)
I don't know how to post a picture, but the fuse panel is in the propane tank bay. just above and to the left. large panel.


LArrycoach 07-03-2021 09:49 AM

Where did you find the 3/4 inch nut to use to manually crank in the slide ?


All times are GMT -6. The time now is 10:50 AM.

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2021, vBulletin Solutions, Inc.