iRV2 Forums

iRV2 Forums (https://www.irv2.com/forums/)
-   Class C Motorhome Discussions (https://www.irv2.com/forums/f87/)
-   -   Squeeky bathroom faucets (https://www.irv2.com/forums/f87/squeeky-bathroom-faucets-554327.html)

cherv 09-17-2021 02:17 PM

Squeeky bathroom faucets
 
Has anyone replaced them and with what? Looking a delta faucets at lowe's coach is 2019 class c 22j

dons2346 09-17-2021 02:24 PM

Find what you like (I prefer Moen) from a big box store and install them. Don't bother with the chae junk from a rv place.

cherv 09-19-2021 11:28 AM

Hi, any issues with install? Do the pex hot and cold pex connectors just screw into new faucet or did you need to modify.

JimBones 09-19-2021 12:22 PM

You could just take them apart and apply a little plumber's grease. You can get it at any hardware store for a few bucks.

The RV faucets usually have pretty short connections to the PEX water lines. Sometimes the residential faucets have longer pigtail connections that are hard to connect to the PEX. You may need to cut the PEX back and add sharkbite fittings.

cherv 09-27-2021 03:42 PM

bathroom faucet s
 
I just installed DELTA FAUCETS on our class c simple took 20 minutes. no more squeaky faucet. and neck is higher for greater access to sink

Ron Dittmer 09-27-2021 05:56 PM

Replacing the bathroom faucet in our 14 year old Phoenix Cruiser was very easy and required "NO" tools and was completed in under 15 minutes. The two water connections were "wing nut style, hand tighten" and the two threaded rings that mount the faucet through the water lines to the countertop were also wing nut style, hand tighten.

Our original bathroom faucet was a cheap white plastic one, the sibling to the outside shower. Here is the replacement. We like the extra height and reach of the spigot along with the swing arm to get it out of the way when needed. I believe it is a Delta, installed maybe 12 years ago.
https://live.staticflickr.com/3395/3...eb685c59_z.jpg

https://live.staticflickr.com/3650/3...92acaa78_z.jpg

I recommend to "first" remove your old faucet so you know the project you are getting into. Then take that with you to the store and get one that mounts identically for a simple straight-forward direct swap.

CaptainSkip 09-28-2021 05:40 PM

I just went through this - take a look at this post that I put up. https://www.irv2.com/forums/f54/head...ts-555829.html


All times are GMT -6. The time now is 12:54 AM.

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2021, vBulletin Solutions, Inc.