iRV2 Forums

iRV2 Forums (https://www.irv2.com/forums/)
-   Country Coach Owners Forum (https://www.irv2.com/forums/f112/)
-   -   Shear Pin/Slide Issue (https://www.irv2.com/forums/f112/shear-pin-slide-issue-71902.html)

wa8yxm 07-22-2010 11:42 AM

Quote:

Originally Posted by elgarc (Post 673361)
I snap our largest slide frequently, I think my desk is heavier at one side than the other end. Care to explain the procedure and advantage of the "bad connection" idea??

You need to cut into a power wire, Either to the control box or to the motor, then you add a small value, high wattage resistor in series. This lowers the voltage to the motor.

The lower voltage means the motor generates less torque

The disadvantage is that it may draw more current and that can do damage

Got the idea when I'd accidently disconnected the batteries and ran it in with low voltage.. VERY SLOWLY

I see Power Gear has a procedure for "Adjusting the amprage" on some controllers... Wish I knew where the controller was.

2005 Damon Interuder 377W

GOLDWINGER2 07-22-2010 12:08 PM

Quote:

Originally Posted by Larry Geese (Post 673538)
03 Camelot. Was leaving one morning "Snap" sheared the pin on the rear slide. Now what? My neighbor had a stick welder. Sounds crude, but welded the great to the shaft, no more problems. I would do it again if I had to.
Larry Geese

The "shear pin" is put there in case of binding, when it breaks it saves you money. (gears, shafts, chains, etc) Not a good idea to bypass the design.
Find the real problem and correct it.
J

JohnFreyja 07-25-2010 04:39 PM

Shear Pin/Slide Issue
 
1 Attachment(s)
Power Gear web site has several downloads of PDF's for troubleshooting and adjusting. I had similar problem and will attach one of the PDF's that might be helpful.
John
05 Inspire
#51399


All times are GMT -6. The time now is 09:47 PM.

Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2022, vBulletin Solutions, Inc.