Sorry to just jump in here but I need some guidance on a related issue.
atwood gc6aa-10e from 2006 or 2007
Gas works. Electric quit recently.
The 12vdc / 120vac relay went bad.
Replaced it with a new one from Atwood.
Still no go.
Followed the 12vdc into the circuit board.
That is good.
Don't find any 12vdc coming out of the circuit board. I think that yellow wire goes to the relay. No 12vdc there either.
I hooked up the heating element directly (skipped the relay) and the element heats up.
So, I am looking for a new circuit board.
Do you recommend going with the same circuit board or is there an improved version available?
Thanks in advance.
John
Quote:
Originally Posted by Old-Biscuit
Can also use a 120VAC 1400W element for the Atwood Brand
They are standard heater elements
Same goes for the T&P Relief Valves..standard component
3/4" NPT (Old Atwoods did use 1/2")
|