Superslif
Senior Member
Registered: June 2000 Location: NE. Ohio USA Posts: 5,973
|
Thu November 29, 2007 8:52pm
|
|
|
On the front bunks of Aerolite Cub's the bunk support cable has 3 upper adjustment holes. At the factory they tend to use the lower most hole which in turn causes the front bunk to rest a little bit lower. You will notice that the velcro would be a little harder to attach. This in turn makes the material tighter, causing a tear in the upper corners. If not caught this tear will spead across the whole top of the bunk end. I would recommend changing the cable to the middle adjustment hole. Doing this will lessen the tightness of the material in the corners.
------------------------------
Jim Kathy & Robert ~ NE. OH.
2018 Outdoors RV Timber Ridge 24 RKS
2023 Toyota Tundra Limited 3.4 TT
IRV2 Photo Album ~Let's Go Places~
|
|